Baumatic BDW45.1, Instruction Manual

Page: 27 / 44

27
E3
o
Longer heating time- not reaching the required temperature.
9
Malfunction of the temperature sensor or heating element.
9
Call Baumatic Service Department.
E4
o
The machine has sensed water in the base.
9
Check that the outlet hose is not kinked or crushed.
9
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
9
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E5
o
Switch cannot shut off automatically- program not finishing its
cycle.
9
Low voltage or power switch failure.
9
Call Baumatic Service Department.
E6
o
Open circuit
9
Thermistor
9
Call Baumatic Service Department.
E7
o
Short circuit
9
Thermistor
9
Call Baumatic Service Department.
o
Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o
Turn the machine on using the ON/OFF button and wait for 5
seconds.
o
Press and hold down the delay start button and the ON/OFF
button, until the appliance switches off.
o
Wait for 5 seconds, and then switch back on the appliance using
the ON/OFF button.
o
Wait for a further 5 seconds before attempting to set a wash
program, using the program selection button.