8
a burning match towards the burner; IT
MUST NOT IGNITE.
Time needed to excite the magnet during
ignition: 10 seconds approx.
Automatic tripping time, after fl ame has been
turned off: not more than 90 seconds for hob
burners; not more than 60 seconds for oven
and grill burners.
IMPORTANT:
- Before doing any work inside the cooker,
disconnect the mains plug and shut the gas
tap.
- Never use matches to check the gas circuit
for leaks. If a specifi c control device is not
available, foam or very soapy water can be
used.
- When re-closing the hob, check that
the electrical wires of the spark plugs (if
present) are not close to the injectors, so
that they cannot run across them.
Before Leaving - Check all connections for
gas leaks with soap and water.
DO NOT
use
a naked fl ame for detecting leaks. Ignite all
burners both individually and concurrently to
ensure correct operation of gas valves, burn-
ers and ignition. Turn gas taps to low fl ame
position and observe stability of the fl ame for
each burner individually and concurrently.
When satisfi ed with the hotplate, please
instruct the user on the correct method of
operation.
In case the appliance fails to operate cor-
rectly after all checks have been carried
out, refer to the authorised service provider
in your area.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat and
moisture in the rooms where they are instal-
led. Take care to ensure that the kitchen is
well ventilated; keep the ventilation openings
unobstructed or install an extractor hood
with fan.In case of intensive or prolonged
use, additional ventilation may be required;
open a window, or increase the extractor
fan power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise
until it reaches the symbol on the control
panel (maximum fl ame position);
- at the same time, move a burning match
towards the burner head;
- to reduce the fl ame, turn the knob further in
the same direction until its pointer is against
the symbol (minimum fl ame position).
FOR HOB BURNERS EQUIPPED WITH
SAFETY DEVICE
- Press the knob and turn it anti-clockwise
until it reaches the symbol on the control
panel (maximum fl ame position);
- move a burning match towards the burner,
keeping the knob pressed right dow for
about 10 seconds;
- then release the knob and check that the
burner remains on. Otherwise, repeat the
operation.
IGNITING THE OVEN BURNER
- Open the oven door;
- press the knob and turn it anti-clockwise to
the maximum fl ame position;
- move a burning match towards the hole in
the centre of the oven bottom and press the
knob right down (see fi g. 9);
- check that the burner has ignited, looking
through the hole in the centre of the bottom,
keeping the knob pressed all the time;
- after about 10 seconds, release the knob
and check that the burner remains on.
Installation
For the user
