background image

TROUBLESHOOTING 

PROBLEM

CAUSE

REMEDY

The inside illumination light bulb does not 

turn on.

• Electricity absence.

• Door switch is blocked.

• The power cord is not properly plugged in.

• Check whether the appliance is switched o

f

f. 

(see 

T

emperature Adjustment).

• Ensure that there is a current in the house.
• Check that it is active.

• The doors are not closed.

• The doors are frequently opened

• Erroneous setting of the temperature.

• The refrigerator and freezer have been 
excessively filled.
• Surrounding temperature is too low.

• No electrical power.

• Check that the door and gaskets close 
properly.
• 

A

void unnecessary opening of the doors for a 

period of time.
• Check the temperature 
setting and, if it is possible, cool even more 
(see 

T

emperature adjustment)

• 

W

ait for the stabilization of the temperature of 

the refrigerator or freezer.
• Check that the ambient temperature is in 
accordance with what is indicated on the
nameplate (see Installation).
• The power cord is not properly plugged in.
• Check whether the appliance is switched o

f

(see 

T

emperature adjustment)

• Ensure that in the home there is current.

The refrigerator and freezer do not suffi

 cient-

ly cool.

The food in the refrigerator freezes.

• Erroneous setting of the temperature.

• Food in contact with the back wall.

• The freezing of too much fresh food causes a 

lowering of the temperature of the refrigerator

• Check the temperature 

setting (see 

T

emperature Adjustment) and, if 

possible, decrease temperature setting.
• Separate the food from the back wall of the 

refrigerator.

• Do not exceed the maximum amount to be 

frozen (see Freezing).

The drain tube could be clogged.

• Clean the drain tube with a stick or the like to 

allow the discharge of water.

The bottom of the refrigerator compartment 
is wet or droplets are present.
Presence of drops or water on the back wall 

of the refrigerator.

• Normal operation of the refrigerator.

• It is not a defect (see Defrosting).

Presence of water in the vegetable drawer.

• Lack of air circulation.

• 

V

egetables and fruits with too much moisture.

• 

V

erify that your glass shelf tray vegetables are 

not put foods that prevent air circulation.
• 

W

rap the fruit and vegetable materials

plastic such as, for example, films, bags or

containers.

The motor runs continuously.

• The doors are not closed.

• The doors are opened frequently.

• Ambient temperature is very high.

• Thickness of frost than 3mm.

• Make sure the doors are closed and if the seals 

close properly.
• 

A

void unnecessary open ports for a certain 

period.
• 

V

erify that the ambient temperature is in accor-

The frozen food is thawing.

• The ambient temperature range below

climate class of the product.

The compressor starts rarely

• The freezer door is not closed.

• Move the unit to a warmer or heat the room.

• Make sure the door is closed and that the 

gasket is sealing properly.

IF YOU ARE NOT SOLVED THE PROBLEM, CONTACT THE SERVICE CENTER, PLEASE GIVE THE TYPE OF FAULT AND THE INFORMATION

ON THE PLATE OF THIS APPARATUS TO INSIDE THE REFRIGERATOR COMPARTMENT:

dance with the specifications on the nameplate 

(see Installation).
• Set the display/thermostat a warmer temperature.

• Defrost the unit (see Defrosting).

EN  10

• The model number.

• 8 digit production code (beginning with 3) Serial number.

Summary of Contents for 34900409













Reviews: