28
Programme Selection
Preparation of Wash Cycle
1.
Load the machine, close the
drum flaps and check that
they are properly locked.
2.
Add detergents and
additives into the dispenser
to no more than the
“MAX“
level mark. Please refer to
“Detergents and additives”.
3.
Turn the
programme
selector knob
to the
desired programme.
4.
Turn the temperature
selector knob (if available)
to the desired temperature.
5.
Press the
spin speed
reduction button,
if
desired.
6.
Select the desired options as
described in the Programme
Chart.
Programme Start
Turn on the tap and press the
“
On/Off
” button. The
indicator light of the
“
On/Off
” button lights up.
Note
: If there is a power
interruption or if the washing
machine is disconnected during
the cycle, the programme will
run again from the point
where it was interrupted.
End of Wash Cycle
The programme selector knob
is in the Stop position “
”.
1.
Press the “
On/Off
” button
to switch off the machine.
2.
Cancel the options.
3.
Turn the tap off.
4.
Wait for the lid to unlock
(about 1 minute).
5.
Open the lid and the drum
flaps and unload the
machine.
Change the Programme
During the Wash Cycle
1.
Switch off the machine by
pressing the “
On/Off
”
button.
2.
Select the new programme.
3.
Start programme by
pressing the “
On/Off
”
button again.
Pause/Interrupt a
Programme
If, for any reason, you wish to
interrupt the programme for a
certain time and continue it
later:
1.
Press the “
On/Off
” button.
2.
After the desired pause,
press the
“On/Off”
button
again.
Cancel Programme
1.
Switch off the machine by
pressing the “
On/Off
”
button.
2.
Set the programme selector
to “Drain”.
3.
Press the “
On/Off
” button
again to start the “Drain”
programme.
