30
DOOR LOCK
The door locks automatically after the
programme starts until the end of the
programme.
The “Door free” indicator goes out.
Exception: In the programmes Cotton and
Synthetics and during the prewash for these
programmes, the door can be opened in order to
add further items during the first 15 minutes after
the start of the programme. This is not possible if
“Rapid Wash” is selected.
If the programme selector is moved to the “
”
position or if the electricity supply is interrupted,
then after approximately two minutes the door is
released.
PROGRAMME END
The programme end is indicated by:
•
The “Door Free” indicator coming on and the
remaining time indicator (if available)
showing “0:00”,
•
An audible tone is sounded three times,
•
The programme sequence indicators are all
off.
CHANGING PROGRAMME OR OPTIONS
1. Set programme selector knob to new
programme. Reselect additional options and
spin speed if appropriate. The indicator light
above the “Start/Pause” button will blink.
Note: The options “Start delay” and “Prewash”
cannot be reselected when the
programme is changed.
2. Press the “Start/Pause” button. The new
programme will continue in the same
programme section during which the current
programme was interrupted.
Note: Do not add more detergent for this
programme.
PROGRAMME INTERRUPTION / PAUSE
To interrupt the running programme for a certain
period and continue it at a later time:
1. Press the “Start/Pause” button.
The indicator flashes.
2. Following the desired pause press the
“Start/Pause” button once again.
CANCELLING THE PROGRAMME
If the current programme is to be terminated
prematurely and cancelled, the water must be
pumped out first before the door can be opened:
1. Set the programme selector to programme
setting “Drain”.
The indicator above the “Start/Pause”
button flashes. The spin indicator shows “0”
and the remaining time indicator (if available)
shows “0:02” minutes.
2. Press the “Start/Pause” button in order to
start the “Drain” programme.
WHEN SHOULD I REMOVE THE FILTER?
Check the filter two or three times a year and
clean it if necessary.
•
Check the filter if the appliance is not draining
properly or if it fails to perform spin cycles.
•
Remove the filter if the pump is blocked by an
object (buttons, coins, safety pins, etc.).
IMPORTANT:Make sure the water has had
time to cool before draining
the appliance.
DOOR LOCK / PROGRAMME END
CHANGING / INTERRUPTING / CLEARING PROGRAMME
REMOVING THE FILTER / DRAINING RESIDUAL WATER
