18
Before contacting After Sales Service:
1. See if you can solve the problem yourself
with the help of the “Trouble-shooting guide”.
2. Switch the appliance on again to see if the
problem has been solved.
If it has not, disconnect the appliance from
the power supply and wait for about an hour
before switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
• the nature of the problem
• the model
• the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance).
• your full address
• your telephone number and area code
Note:
The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
•
Install the appliance away from heat sources.
Installation in a hot environment, direct
exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will
increase power consumption and should
therefore be avoided.
•
Do not obstruct the circulation of air above
and below the appliance.
•
Clean the inside (see section “Maintenance
and Cleaning”).
Electrical connection
•
Electrical connections must be made in
accordance with local regulations.
•
Voltage and power consumption are
indicated on the rating plate located inside
the appliance at the side of the crisper.
For free-standing appliances
(not built-in)
•
The following minimum distances must be
respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
•
To optimise appliance efficiency, leave a 5
cm gap above the appliance and make sure
that adjacent kitchen units are sufficiently
distanced to allow air circulation.
•
Fit the spacers (if supplied) at the rear of the
appliance (see figure).
•
Install the refrigerator in a dry, well-ventilated
place. Make sure it is level. Adjust the front
feet if necessary.
•
Fit the accessories.
•
Regulations require that the appliance is
earthed. The Manufacturer declines all
liabilities for injury to persons or animals
or damage to property resulting from
failure to observe these regulations.
•
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
•
Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance
by unplugging it or by means of a two-pole switch
fitted upline of the socket.
AFTER-SALES SERVICE
INSTALLATION
33110Gb.fm5 Page 18 Monday, June 28, 1999 3:50 PM
Summary of Contents for KDA 3710
Page 4: ......
