D
F
NL
E
P
GR
DK
S
N
FIN
I
GB
PRODUCT SHEET
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
•
Press button
E
once to adjust the internal temperature: the digital display shows the temperature previously
set.
•
Each time the button is pressed, the temperature setting is changed by 1°C: the value (between -16°C and
-24°C) blinks cyclically on the display.
•
Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored,
the display stops blinking and the current internal temperature is shown on the display.
•
Note:
The digital display shows internal temperature values b10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function switches off automatically when freezing is complete.
Alarm signals
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following the
introduction of fresh food in the freezer compartment; this temporary rise in temperature does not affect the
storage of already frozen food in any way.
Defrosting (for No Frost models no operation is required)
This appliance defrosts automatically according to usage and ambient humidity conditions.
Follow the steps detailed in “Switching on the appliance”.
For not No Frost models, follow step 1-6:
Signal
Cause
Solution
Door open alarm
The acoustic alarm is activated
The door has been left open
for more than 1 minute
Close the door
Temperature alarm
The acoustic alarm and red LED
C
are activated
The internal temperature is
above -12°C
Press button
G
; wait for
the temperature to fall
below -12°C again
Temperature sensor
alarm
The acoustic alarm is activated and
the display shows
“SF”
Temperature sensor fault
Contact After-sales
service
Prolonged power failure
alarm
The acoustic alarm and red LED
C
are activated; the display blinks,
indicating the highest temperature
reached following the power failure
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which correct
food storage cannot be
guaranteed
Press button
G
; the
display now indicates the
current internal
temperture
1.
Press the freezer on/off button
D
.
An illuminated dot appears on the digital display.
2.
Unplug the appliance or switch off at the main
switch.
3.
Fit the drain in place (see figure).
4.
Follow the instructions given in the
instructions booklet.
5.
Plug in the appliance once again.
6.
Press the freezer on/off button
D
.
Follow the steps detailed in “Switching on the
appliance”.
The 6th Sense/“Dynamic Intelligence” function (blue LED) is automatically activated due to door opening and
when small amounts of fresh food are placed in the freezer. The duration of the 6th Sense function varies
depending on the quantity of food loaded in the freezer and ambient temperature. When optimal operating
conditions have been restored the function deactivates automatically and no operation is required.
5019 608 01058
Printed in Italy
03/09
