BAUKER SBC30, Original Instruction Manual

Page: 35 / 44

EN-35
5. Hold the product stable and pull the recoil starter handle firmly; repeat until the engine
starts. (See Fig. K4) Allow the recoil starter rope to return slowly and controlled after each
pull!
WARNING!
Make sure that the cutting blade is not touching the ground or other objects
when starting the product!
6. Allow the product to run at idle speed for 10 to 15 seconds to let it warm up.
7. Once the engine is running correctly, carefully lift the product and securely hold it by its
handles.
NOTE: During idle running the cutting blade should not move. Contact a qualified
technician if you find that the cutting blade is moving.
OPERATION (See Fig. L)
1. Press the throttle interlock, hold it in position and then press the throttle trigger to
engage the attachment.
2. Release the throttle trigger, this tool will be set at idle speed status.
STOPPING THE MACHINE (See Fig. M)
1. Release the throttle trigger and let the product run at idle speed for 10-15 seconds.
2. Set the ignition switch to the “O” position.
WARNING!
The attachment will continue to move for some time even after the engine
has been switched off! Wait until the attachment has come to a complete stop before
placing the product on the ground!
GENERAL BEHAVIOUR
1. Check the product as well as accessories for damage before each use. Do not use the
product if it is damaged or shows wear.
2. Double check that accessories, safety guards and blades are properly fixed.
3. Always hold the product the product by its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clean. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
5. Switch the product off immediately if you are disturbed while working with it and when
other people enter the working area. Always let the product come to complete stop before
putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate on the
work and have full control over the product.