EN-11
Intended Use
The power tool is intended for sawing and remodelling wooden materials, plastic, plaster, non-ferrous
metals and fasteners (e.g. nails and clamps) as well as for working on soft wall tiles and for dry grinding
of small surfaces. It is especially suitable for working close to edges and for flush cutting.
1. ASSEMBLING ACCESSORIES
Caution: For all work or when changing accessories, always wear protective gloves. Avoid risk of injury
from the sharp edges of the accessories. Accessories can become very hot while working, presenting
danger of burns! Make sure the tool is unplugged prior to changing accessories.
Warning: To reduce the risk of injury, do not let the sharp side of the accessory face back toward the
user’s hand.
To change the accessory
Flip the tool- free blade change lever (1) forward to the open position and take off the flange (7) from the
machine. (See fig. A)
Insert the accessory onto the blade interface (6), Make sure / ensure the accessory is on the right
position of the blade interface (6). (See EXAMPLE Fig. B1, B2)
Re-insert the flange (7), press the flange (7) to keep the blade or other accessory temporarily secure. Flip
the tool- free blade change lever (1) back to original position to secure the accessory. (See Fig. C1, C2)
MOUNTING / CHANGING THE SANDING SHEET (See Fig. D, E)
2a) Flip the tool-less blade change lever (1) forward to the open position to loosen the flange (7).
Remove universal end cut blade. Insert the sanding pad (12) onto the accessory interface (6), then (if
necessary, re-insert the flange) press down the flange with finger to keep the blade temporarily secure.
Flip lever (1) back down to seated position to secure accessory.
2b) Place the mesh sanding sheet directly onto the base plate and press the sheet onto the pad. Firmly
press the oscillating tool with the installed sanding sheet against a flat surface and briefly switch the
power tool on. This provides for good adhesion and prevents premature wear. If one point has become
worn after use, pull off the sanding sheet, turn it 120°, and re-install.
2. OPERATING THE ON/OFF SWITCH (See Fig. F)
——Switching the power tool ON:
Slide switch forward.
——Switching the power tool OFF:
Slide switch backward.
3. USING THE VARIABLE SPEED DIAL (See Fig. G)
Select oscillation frequency (speed) while the motor is running.
The Variable Speed Dial can be used to set the optimum oscillating frequency according to the
accessories used and the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency:
Scraping, polishing varnishes.
4. SIGHT LIGHT (See Fig. H)
The sight light allows you to keep a clear view under less illuminated circumstances. To turn on the light,
simply press the on/off switch. When you release the on/off switch, the light will turned off.