BAUKER CGT18LW, Original Instruction Manual

Page: 13 / 20

EN-13
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for the cutting of grass and weeds under bushes, as well as on slopes and
edges that cannot be reached with the lawn mower.
1. ASSEMBLY OF AUXILIARY HANDLE (SEE FIG. A1, A2)
Insert the shaft onto the upper housing. Hand grabbing area should face down(See A1). Attach the screw
to the housing unit, and then to the knob. Finally, rotate the knob until it is hand tight. (See Fig. A2).
NOTE: Make sure that the handle is firmly locked in place.
2. ASSEMBLY OF THE SAFETY GUARD (SEE FIG. B1-B3)
Remove the screw (a) from the guard. (See B1) Attach the safety guard to the trimmer head. Align the
guard so it slides into the slots located on the trimmer head.(See B2) Secure the safety guard onto the
trimmer head with the screw (a). (See B3)
3. REMOVING THE BLADE PROTECT LABEL (SEE FIG. C)
The blade is covered with a protect label. Please remove it before operation.
OPERATION INSTRUCTIONS
WARNING! The charger and battery pack are specially designed to work together so do not
attempt to use any other devices. Never insert or allow metallic objects into your charger or
battery pack connections because of an electrical failure and hazard will occur.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY (SEE FIG. D)
NOTE:
a) Do not use any charger other than that specifically provided for use with the equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger and allow time for
the battery to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged
before using the first time
d) Please charge the battery to reach full or no less than half charge before storage. If the tool will not
be used for long periods of time, charge the battery every 3-6 months
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has
started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING!
When battery charge runs out after continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before re-charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs, insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the original pack is defective and should be returned to
a service center or recycling service center. If the new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an authorized service center.