BAUKER BTC180B, Original Instruction Manual

Page: 11 / 16

EN-11
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
Caution: Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
1. FITTING AND ADJUSTING THE BLADE GUARD BRACKET/BLADE GUARD
Before use, the blade guard bracket and blade guard must be fitted to the cutter.
Remove machine from packaging, loosen the securing plate slightly by unscrewing the two screws(13).
Note the screws and securing plate is preassembled on the worktable. (See A)
Align blade guard bracket on top of table and tighten the two screws(13).
Unscrew the bolt(14) on blade guard, insert the blade guard bracket into the guard through the slot. Re-
fit the bolt on blade guard.
2. FITTING AND CHANGING THE BLADE
1) Loose the screws(15), remove the blade guard cover (See B).
2) Undo the securing nut using two wrenches (See C).
3) Remove the outer domed washer and the blade.
4) Mount the new blade recommended by the manufacture on the arbor and place back the outer
domed washer. Turn the blade 360 degrees to make sure it matches with the domed washers
properly.
Fully tighten the securing nut.
Note:
●
Fit the inner and outer domed washers in proper order. They have the different centre holes. (See D)
●
Ensure that the arbor and domed washer are clean.
●
Match blade direction arrow to blade rotation direction (wording on wheel facing you).
●
Use a protective glove to hold the diamond wheel during tightening.
5) Fit the blade guard cover over the blade. Re-tighten the screws (15).
3. FITTING THE PARALLEL GUIDE (SEE E)
Position the parallel guide on worktable as shown. Align the holes in the fixing plates with the holes in
the upright ends of the parallel guide fix with the two securing knobs (2) provided.
Note:
The fixing plate should be fitted on the inside surface of the work table edges.
OPERATING INSTRUCTIONS
Residual circuit device (RCD) operation (see F) (only for BTC180B.1)
Function
This RCD device will cut off the power immediately when it detects an electricity leakage in your power
tool.
How to use
1.Connect the RCD device into a main power supply. Push the “RESET” button and confirm that the
pilot lamp lights.
2.Press the “TEST” button on the RCD, the RCD will cut off the power supply. The pilot lamp is off.
3.Press the “RESET” button again, the RCD is ready to use and the pilot lamp turns red. If the pilot lamp
does not turn red, wait 6 seconds before pressing again. Repeat until the pilot lamp turns red. If after
several attempts, the pilot lamp still fails to turn red, please check the fuse of the plug and replace if
necessary (only for UK).
Note:
When pressing the “TEST (16)” and “RESET (18)” button, do not hold for more than 1 second.
4.When the pilot lamp (17) is off, the RCD is power off (electricity leakage occurs or the RCD is on test).