11
1300 886 649
Model: AWBS-0818-W Product Code: 61485 08/2018
www.tempo.org
AUS
Installation (Cont.)
For TVs with 400x400 VESA pattern:
a) When the wall plate is properly attached to the wall, pull the swing arm
out as far out from the wall as possible.
b) Lay your TV face down on something soft so as not to scratch the TV
screen. Check the back of your TV to find the appropriate mounting
pattern.
c) Select Screws (G), Washers (D) and Nuts (J) to attach the TV mounting
plate arms to the TV mounting plate as shown in the diagram below. (See
Fig. 6 below). Use TV mounting plate arms type 1 on the top right and
bottom left corners, and type 2 on the top left and bottom right corners.
NOTE: Use a Phillips-head screwdriver and socket wrench to securely
tighten the TV mounting plate arms to the TV mounting plate.
d) On the rear of the TV, locate the screw holes used for attaching a wall
bracket. Position the assembled TV mounting plate over these holes.
Insert the four selected bolts through the appropriate washers (C/D/E)
and the corresponding holes on the TV mounting plate and into the
thread holes on the back of the TV, as shown in Fig. 5 on page 10. (The
illustration shows the TV mounting plate without the attached swing arm
and wall plate, for better visibility). Then tighten the bolts.
e) Carefully lift TV and hook the TV mounting plate over the swing arm. Do
not let go of the TV until the it is securely in place on the swing arm.
f) Tighten the locking bolt to secure the TV using a Philips-head
screwdriver. This will help ensure that your TV does not fall off the wall
mount during use.
NOTE: Ensure you have two people to perform steps (e) and (f) to avoid
damaging the TV or causing injury.
(J) Nuts
(D) x Washer
(G) x Screws
1
2
1
2
Fig. 6
