11
1300 886 649
Model: AAVCW-0419 Product Code: 64588 04/2019
www.tempo.org
AUS
Waterproof Housing
The camera comes supplied with a transparent waterproof housing, which
allows you to take video footage or photos in wet conditions or under water
at a depth of up to 30 meters.
To use the camera with the waterproof housing, observe the following:
• Select the desired menu options.
• Place the camera in the waterproof housing and close it carefully using the
locking clip located at the top of the case. Make sure the latch lock key is
securely in place.
• Once the camera is securely installed, you can use the ON/OFF and
Shutter buttons by pushing the push buttons located on top of the
waterproof housing.
WARNING:
Once the camera is secured in the case, make sure that all seals
are in place to prevent water intrusion.
Getting Started (Cont.)
Before using the camera in wet conditions
• Before sealing the case, ensure the rubber seal of the camera housing
is clean — even a single hair or grain of sand can cause a leak. You can
test watertightness by closing the case without inserting the camera.
• Submerge the empty case completely in water for about a minute.
Remove the case from the water, dry off its exterior with a towel,
then open the case. If the entire interior is dry, the case is safe for use
underwater.
• After using the camera in saltwater, rinse the outside of the housing
with non-saltwater and dry. If not properly cleaned, corrosion can occur
on the hinge and the pin, which can cause failure.
•
WARNING:
Do not use aggressive substances such as acetone to
clean the case, as these can cause permanent damage.
• To clean the seal, rinse in fresh water and shake dry (drying with a cloth
may cause lint to compromise the seal). Re-install the seal into the
grooves in the back door of the housing.
