Page 13
For technical questions, please call 1-888-866-5797.
Item 58862
SA
FE
TY
OP
ERA
TI
O
N
MAINT
ENANC
E
SE
TUP
Troubleshooting
Problem
Possible Causes
Likely Solutions
Disc Sander
does not turn on
1. Not plugged in.
2. No power at outlet.
3. Safety Key not inserted into Switch.
4. Switch is not turned “ON”.
1. Plug in Sander.
2. Check power at outlet and/or circuit breaker.
3. Insert Safety Key into Switch.
4. Turn on the Switch.
Motor overheats 1. Motor overloaded.
2. Extension cord too long
or insufficient gauge.
1. Use less pressure.
2. Use appropriate extension cord or
plug tool directly into outlet.
Motor slows
when sanding
Applying too much pressure
while sanding
Use less pressure.
Wood burns
while sanding
1. Sanding Disc may be loaded
with dirt or debris.
2. Too much pressure.
3. Sanding grit too fine.
1. Clean or replace disc using
instructions in this manual.
2. Use less pressure.
3. Use coarser grit Sanding Disc.
Deep Grooves/
Scars in
workpiece
1. Sanding Disc too coarse.
2. Too much pressure.
3. Workpiece being held
against disc for too long.
4. Sanding against the grain.
1. Use finer grit disc.
2. Use less pressure.
3. Keep workpiece moving when sanding.
4. Sand with the grain.
Sanding
surface clogs
1. Too much pressure against
Sanding Disc.
2. Sanding softwood.
1. Use less pressure.
2. Clean or replace Sanding Disc frequently.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
