Page 11
For technical questions, please call 1-888-866-5797.
Item 64856
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Specifications
Electrical Rating
120VAC / 60Hz / 7A
No Load Speed
11,000 RPM
Arbor Size
5/8 - 11 UNC
Wheel Diameter
4-1/2
″
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
ASSEMBLY
Installing the Wheel Guard
TO PREVENT SERIOUS INJURY: Do not operate this tool without the Wheel Guard properly installed.
1. Pull the Clamp Handle open to
loosen the Wheel Guard.
2. Slide the collar of the Wheel Guard
over the rim of the Gear Housing.
3. Rotate the Wheel Guard as needed to
shield you during the planned work.
4. Once in place, push to close the Clamp
Handle to secure the Wheel Guard.
5. Check the Wheel Guard to ensure
it is firmly in place. Adjust if
necessary before proceeding.
Wheel Guard
Clamp Handle
