B A T H O L O G Y
by
Apply silicone into and around entire top of
sensor guard anchors (flange) before inserting
screws (flange), creating a seal between anchor
and wall.
Attach screws (flange) into the corner wall
anchors (flange) leaving 1/8” gap from screw
head to wall.
Fasten sensor screw mount to the center wall
anchor.
Feed sensor tie through sensor screw mount
and secure sensor in place.
Apply silicone around wire exit area to create a
water-tight seal.
Line up holes on rear of sensor guard with
screws.
Slide sensor guard slightly to the left until screw
heads are visible.
Tighten screws.
Allow silicone to cure for 24 hours before
exposing product to any source of moisture.
7.
8.
9.
10.
11.
12.
13.
14.
15.
Sensor and Sensor Guard Installation
(cont.)
There is a trimpot located on the back of the
PreciseTemp 320 for easy recalibration. Remove
tape covering the trimpot and F/C switch. Compare
the display with a temerature standard (NIST,
certified mercury thermometer, etc.). Adjust the
trimpot so that the meter’s digital display matches
the temperature standard (see Figure 3). Replace
the tape after calibration.
F°/C° Switch
Calibration Trimpot
Battery
Figure 3
Thermometer Calibration
3
Product Care
For routine cleaning simply use a soft damp cloth
and common household soap. Use a damp cloth
to wipe clean, then dry. Clean product frequently to
avoid calcium deposits on surfaces. Use only mild
soap based detergents. Never use abrasive
cleaners, bleach, disinfectants or cleaning products
containing alcohol, ammonia, hydrochloric or
phosphoric acids as they will damage the product’s
finish.
Battery Replacement
Remove back cover screws (4) to expose internal
PCB assembly. Remove battery and replace with
G-13A, 1.5V button cell battery. Replace back
cover.
Note: When replacing back cover, be sure that the
snaps line up with the holes in the case and that the
wire is positioned correctly in its “cut out”.
Farenheit/Centigrade Operation
There is a switch located on the back of the
PreciseTemp 320 for easy farenheit to centigrade
conversion. Remove tape covering the switch and
simply flip the switch to the desired scale of
operation (see Figure 3). Replace tape after using
the F/C switch.
900-0503-1014
P r e c i s e T e m p 320
B A T H O L O G Y
r e d i s c o v e r b a t h i n g
A division of Bathing Brands, Inc.
www.Bathology.com 847-465-1070
