4
3.
Do Not Completely Tighten Nuts:
(Mounting bases must rotate freely
so the seat can be adjusted.)
2. Install mounting bases on bowl.
a)
Insert clear plastic ribbed inserts into
the holes in the toilet.
(Do not worry
if holes in seat do not align with holes
in toilet.)
b)
Insert screws through rectang
ular
washer, mounting base and clear
plastic ribbed insert.
c)
Install washers and nuts.
1.
Remove old toilet seat (if necessary).
IMPORTANT: Make sure toilet bowl is clean and dry, especially around the mounting
holes, with no chemical residue. Mounting surface must be level.
IMPORTANT!
Black rubber washer
goes on first, then white washer and
finally, the white wing nut.
4-3/4 in.
IMPORTANT!
IMPORTANT:
Rotate mounting bases so
posts face forward (closest to front of
the bowl, not tank). Using tape measure
or ruler, adjust bases so posts are 4-3/4
inches apart.
Do not tighten nuts.
