Installation and Maintenance Manual: RLVDC
Published February 2022
16
9. Slide the roller through the old band in circle 3 of Figure 7. Then slide the roller through the new
band. (This step can be difficult as the bands are tight.)
10. Once the roller has both bands around it, guide the hex shaft into the hex hole.
11. Once the groove side hex shaft (Left side in Figure 7) is within the hex hole, insert the opposite
side hex shaft into the appropriate hex hole. Use the roller’s length as leverage to aid in this step.
As called out in the roller replacement procedure, use a putty knife or other flat surface tool to
protect the paint on the side frame.
12. If the band being replaced is on the inside groove/hub of the roller as shown in the blue circle of
Figure 7, then remove the hex shafts opposite the groove/hub.
13. Roll the band being replaced down the length of the two rollers.
14. Roll the new band up the length of the two rollers.
15. Re-insert the hex shafts into the appropriate hex holes.
16. Replace side covers.
Figure 7: Band Replacement
