Installation & Maintenance Manual: BRBAC 1 HP
Published December 2019
Rev.A1
26
4.
On installation of the noseover section to both adjacent conveyor sections, the noseover is set
up a rough desired angle.
5.
Measure the dimension referred to in Figure 19 on both sides of the noseover section. Ensure
that the dimensions on both sides of the noseover sections are within 1/16” of each other.
Figure 19: BRBAC noseover section - location of check dimension
6.
Tighten the 3/8” carriage bolts and serrated flange nuts on the adjustment bracket to hold the
specific adjusted noseover angle. The torque requirement for 3/8” carriage bolt and
serrated
flange nut is 31 ft-lbs.
5.6
Installing Underside Covers
The underside covers are an accessory item ordered to specification per BRBAC mark. The underside
covers are shipped separately on a skid. The only exception is the underside covers installed on the
BRBAC drive sections.
The overall width of the underside cover is approximately 1/8” less than the between frame width of the
BRBAC section. All underside covers supplied come with underside cover splice plates for installation.
The order of installing underside covers is as follows:
1.
Drive section.
2.
Tail Section.
3.
Noseover Section
–
if applicable
4.
Bed section.
The following instructions outline the operational procedure to install underside covers.
1.
Identify the underside cover for the installed BRBAC section.
2.
It is recommended to install (1) splice plate at every corner of the underside cover and at least
(1) splice plate every 36” on each side
. Refer to Figure 20 that shows an exploded view of the
splice plate install on the side covers. The splice plate is installed using 3/8” carriage bolt and
serrated flange nut. The torque requirement for the
3/8” carriage bolt and serrated flange nut is
31 ft-lbs.
Location of noseover
check dimension
Summary of Contents for BRBAC 1 HP
