Basler L800k, User Manual, Page: 71 / 168

Operation and Features
BASLER L800
k
3-31
Draft
As mentioned above, the dark noise cancellation feature has no effect in edge-controlled mode.
If you work in edge-controlled mode and enable the dark noise cancellation feature, you will see
no image enhancement but a slight delay in both the start and the end of exposure as shown in
Table 3-7.
Enabling Dark Noise Cancellation
You can enable the dark noise cancellation feature with the Camera Configuration Tool Plus
(CCT+) or by using binary write commands from within your own application to set the camera’s
control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1 ), you use the Dark Noise Cancellation parameter in the Image
Enhancement parameters group to enable dark noise cancellation.
By Setting CSRs
You enable dark noise cancellation by writing a value to the Mode field of the Dark Noise
Cancellation CSR (see page
4-40 ).
See Section 4.2.2 for an explanation of CSRs and Section 4.3.1 for an explanation of using read/
write commands.
Exposure Mode L801
k
Start Delay L801
k
End Delay
Edge-controlled 217.6 (+0.7/-0.0) µs 217.6 (+0.7/-0.0) µs
Exposure Mode L802
k
Start Delay L802
k
End Delay
Edge-controlled 108.8 (+0.5/-0.0) µs 108.8 (+0.5/-0.0) µs
Exposure Mode L803
k
Start Delay L803
k
End Delay
Edge-controlled 72.6 (+0.5/-0.0) µs 72.6 (+0.5/-0.0) µs
Table 3-7: Exposure Start and End Delays in Edge-controlled Mode