Basler L301kc, Installation And Operating Manual

Page: 17 / 124

Camera Interface
Basler L301kc 2-3
DRAFT
6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Figure 2-2: L301
kc
Pin Numbering
2.1.3 Connector Types
The 26 pin connector on the camera will be a female .050” MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera is a Hirose micro-miniature locking receptacle (part # HR10A-
7R-6PB) or the equivalent. The recommended mating connector is the Hirose micro-miniature
locking plug (Part # HR10A-7P-6S). A plug of this type will be shipped with each camera. The plug
should be used to terminate the cable on the power supply for the camera.
Pin
Number
Signal
Name Direction Level Function
1, 2
1 12 V In Input +12 VDC Camera Power Input
3 Not Connected
4 Not Connected
5, 6
2
DC Gnd
Input Ground DC Ground
1
Pins 1 and 2 are tied together inside of the camera.
2
Pins 5 and 6 are tied together inside of the camera.
Table 2-2:
L301
kc
Pin Assignments for the 6-pin Micro-miniature Receptacle
Caution!
Do not reverse the polarity of the input power to the camera. Reversing the po-
larity of the input power can severely damage the camera and leave it non-op-
erational.
!