Installation / Assembly
dizzer® XL Series Modules for Open Platform
– Assembly Instructions 1.1(2019-01) E inge
Page 33 of 44
© inge GmbH
2
Placing the module
a)
Place the module vertically on the appropriate connection
point on the module rack.
Make sure that the connections on the module are
flush with the connections on the module rack..
b)
Hold the module in position and fasten it to the module rack
with two brackets (on the top and bottom third of the
module).
Make sure that the connection is tight, stress-free and
vibration-free.
3
Lubricate the gaskets with glycerin
a)
Remove the gasket rings of the 2" composite coupling set.
b)
Lubricate the gaskets with glycerin on the inside and
outside.
c)
Place a lubricated gasket ring over a connection on the
module.
d)
Push the gasket ring onto the connection so that it is flush
with the connection.
e)
Repeat procedures a) to d) for all further connections on
the module.
