BaseWall, Tel: +31-74-2491004, Fax: +31-74-2593934
30
Advanced configuration – virtual server
Virtual Server Configuration
•
Enable
– The enable checkbox is to Enable or Disable each Virtual server as required.
•
Server Name
– Enter a suitable name for this server. (By default, there are 12 well-known
virtual servers have been list on the Custom Virtual Server List)
•
Protocol
– Select the network protocol (TCP/UDP) used by this sever.
•
IP
Address
–
LAN
, Enter the IP address of the server on your LAN which is running the
required Server software.
Each Host (server) should have a fixed IP address, or have a reserved IP address. (See the
Host IP
section earlier in this Chapter for details on reserving an IP address.)
Each Host (server) must be running the appropriate Server software
•
WAN
– This selection allows this server to bind on any WAN ports, or even bind all WAN
ports together.
•
LAN Port Range
– Enter the range of port number used for outgoing traffic from this
Server. If only a single port is required, enter it in both fields.
•
WAN Port Range
-– Enter the range of port number used for incoming traffic to this Server.
If only a single port is required, enter it in both fields
•
Allowed Remote IP
– It allows only a range of remote side IP address to access the virtual
servers. The default is 0.0.0.0 ~ 0.0.0.0, means all remote side IP address can access it.
Buttons
•
Add
– Create a new Virtual Server entry.
•
Delete
– Delete the selected entry.
