ME9000LH-17/25 EXCELA-WYND
™
HOSE REEL OPERATING INSTRUCTIONS
Form #1176-OP, Excela-Wynd
™
Operating Instructions
Page | 2
P/N 9000584 Rev E, 7-7-22
TIPS for Operating the EXCELA-WYND
™
Hose Reel
•
When using an ASKW remote, your service provider can adjust the rewind speed to match driver or seasonal needs.
•
Avoid twisting the hose excessively to prevent binding on the reel and assure reliable automatic loading.
•
If you have a loss of truck battery power to the reel controller while the hose is pulled out, such as when using the
emergency shut down, when the power is restored the hose reel speed controller will temporarily rewind at a slower speed.
Once the hose is fully rewound on the reel, turning the truck ignition off and back on will reset the rewind speed.
TO RAISE THE COVER
- Pull the
front detent pin, push the front of
the cover to the left to release it,
and rotate it upward. Latch and pin
cover when done.
TO REMOVE THE COVER
- Pull both
detent pins, push the cover to the
left to release it, and lift it upward.
Latch and pin cover when done.
TO USE THE MANUAL CRANK
- (Remove crank from storage pouch and remove red safety cap)
1)
Insert the safety collar into the axle.
2)
Push in and turn to engage drive pin.
When the hose is loaded, remove crank, replace safety cap and place in storage pouch.
Note:
Turning the truck ignition off releases the reel brake making it easier to turn.
TO CHANGE REEL IN SPEED USING A PC3 REMOTE
1)
Press the
“REEL SPEED”
button to bring up the Reel In speed screen.
2)
Use the
“
UP
”
and
“
DOWN
”
arrows to highlight the desired speed.
3)
Use
“SELECT”
to accept the highlighted speed.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES AND SOLUTIONS
•
The reel brake doesn’t
release when pressing
REEL OUT
•
The reel won’t turn
at all
when pressing
REEL IN
•
The batteries in the remote may be too low to transmit or may transmit only a short distance - Recharge
or replace batteries.
•
The truck ignition may be off, removing power from the controller - Make sure the ignition is on and the
brake is set.
•
The PTO may be on - To prevent accidental operation while filling, REEL IN is disabled when the PTO is on
- Turn the PTO off before activating REEL IN.
•
The reel stops turning
while pressing
REEL IN
(Rewind)
•
An extremely high motor load may have triggered the over-current protection - It will automatically
reset after (5) seconds.
•
The hose may be stuck on an obstruction - Check for and clear any obstructions.
•
The hose may have bound in the reel due to excessive twisting - If the hose is bound or not evenly
layered on the reel, pull out any hose that is bound, remove excessive twist and rewind hose.
