BAS-IP AV-07T, Manual

Page: 49 / 75

Installation and connection – 49
Installation and connection
This page describes the process of installing and connecting the panel.
• Product completeness check
(see page 49)
• Electrical connection
(see page 49)
• Mechanical mounting
(see page 52)
• Connection of additional modules
(see page 63)
Product completeness check
Before installing the call panel, be sure to check its completeness and the presence of all
components.
Is included in the package of the outdoor panel:
Outdoor panel 1 pc
Mounting bracket for flush installation 1 pc
Set of plugs for connections 1 pc
Installation manual 1 pc
Installation screws with key 1 pc
Sealing rubber 1 pc
Protective cover 1 pc
O-ring 1 pc
Strap for assembly work 1 pc
Electrical connection
After checking the completeness of the device, you can proceed to the connection.
To connect you will need:
• Ethernet cable UTP cat5 or higher connected to a network switch / router.
• To connect the panel via PoE, you need to use a switch that works with 802.3 af support
with a maximum power per port of no more than 15.4 watts.
Cable lenght recomendations
The maximum length of a UTP CAT5 cable segment must not exceed 100 meters,
according to the IEEE 802.3 standard.