EN
page 44
3.7 Extra cold rinse function (option)
This function can only be enabled if the machine is equipped with the optional
Cold rinse
function.
Machine ON. Press the key
C
.
After the normal rinse cycle an extra cold rinse is made for few seconds with tap water.
During the wash cycle or manual draining the type of rinse selected cannot be changed.
The Extra cold rinse function selection is displayed by the
F7
indicator lighting.
Note:
The Additional Cooling selection is not memorized. It must be set every time the machine is switched o
ff
and then on
again (if this function is required).
WARNINGS:
• Do not slam the door when opening and closing.
• Do not put material or objects on the machine.
• The machine has an IP (see serial number label on the machine) protection rating against accidental water splashes
and is not protected against pressurized water jets. Pressure-cleaning systems shall, therefore, not be used on this
machine.
• Do not dip bare hands into water containing detergent. If this should occur, wash them immediately with plenty of water.
Check the safety instructions on the detergent container.
• Some important rules must be followed for using this appliance:
1) never touch the appliance with wet hands or feet;
2) never use the appliance when barefooted;
3) do not install the appliance in places exposed to water splashes.
• This machine must be disconnected from the main electrical supply after use at the end of the day and for any
service/maintenance operation. Switch off the main switch located on the wall, which shall be installed by a
professional installer. Shut the water supply valve(s).
• Do not cover the intake or dissipation grids.
• Do not use water to extinguish
fi
res on electrical parts.
WARNING: INTERNAL CLEANING OF THE MACHINE SHALL BE CARRIED OUT AT LEAST 10 MINUTES AFTER
THE POWER SWITCH HAS BEEN TURNED OFF.
WARNING: DO NOT INSERT HANDS AND/OR TOUCH THE PARTS LOCATED AT THE BOTTOM OF THE WASH
TANK AND/OR AT THE END OF THE WASH CYCLE.
3.8 Inlet water temperature probe (option)
The machine can be equipped with a built-in inlet water probe that allows verifying the boiler inlet water-temperature.
With machine in ready-mode, by pressing both the key
A
and
C
it is possible to visualize the temperature.
Summary of Contents for US PPlus500 LPWR
Page 6: ...EN page 34...