INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 10
UK
Proceed as follows (
Fig. 11
):
Switch the dishwasher off
Empty and clean it.
Remove the integral filter and open the salt container in the tub.
Pour in 250-300g of regeneration salt (1 or 2mm grain size kitchen salt with no additives).
Close the container firmly.
Make sure the overflow has been removed.
To start the cycle, with the machine off press
START (3)
for a few seconds.
The cycle is shown by the
POWER (5)
led coming on and the
CYCLE UNDERWAY (5)
led flashing.
The regeneration cycle lasts around 20 minutes.
The dishwasher will switch off when the cycle has completed.
N.B. Do not switch the machine off during the regeneration cycle
4.9
End of shift
At the end of the day always drain the machine as described in the section Machine draining.
Disconnect the power supply by means of the main switch and close the external water cock.
Perform routine maintenance and clean the machine as described in the section Maintenance.
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Chap 5
MAINTENANCE
5.1
General rules
Before doing any maintenance, completely drain out all water, shut off the power
supply and close the water supply cock.
Do not use water under pressure - it can damage the electrical equipment.
Only wash the body panelling when it is cold, using only product specifically designed for steel.
If there is a risk of ice forming, drain the water from the boiler and wash pump.
5.2
Cleaning
To keep the machine in good working order, it must be maintained regularly as explained below. We
recommend periodically running a sanitising treatment with suitable non-corrosive commercial
products.
5.3
Cleaning the filter unit
Run this procedure at the end of the day or when you see the filters are dirty:
1. Remove and clean the baskets.
2. Empty out the tub as explained in “Machine draining”.
3. Remove and carefully clean all the filters.
4. Do not use abrasive products to clean the tub.
5. Restore all removed parts when finished.
