- 41 -
To properly install the device, please follow the instructions below:
water connection must be equipped with a shut-off valve to block the water
supply;
pressure in the water supply network must be within the range of recommended
values;
in order to optimize the device operation, the manufacturer recommends that
the temperature at the water inlet to the device should be within the ranges
provided in the following table;
Cold water
Hot water
5 °C - 25 °C
40 °C - 60 °C
in case of using hot water, the water temperature cannot exceed 60 °C;
the device is equipped with a threaded connection (¾").
5.5 Drain connection
The water must be drained freely from the device. Due to this, the drain hose must be
located below the device in a way which makes the draining of water possible (
Fig. 4)
.
The device is equipped with a drain pump, which pumps out the water after washing
when setting the control knob to (G) position (fig.7 page 36).
In such a case, the height of 800 mm cannot be exceeded (
Fig. 5
).
Fig. 4
. Drain mounting.
Fig. 5.
Setting of the drain height through the drain pump.
5.6 Cleaning agent dosing pump
The device is equipped with a cleaning agent dosing pump. Thanks to his dosing device
the appropriate quantity of cleaning agent is added to the wash-tank each time.
Operation:
a cleaning agent dosing pump is activated when the device collects water
during the filling process.
Setting:
a quantity of cleaning agent should be set up during the installation, because
only this way the user may use all washing features in an optimum way from the very
beginning.