- 24 -
•
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
•
Place the device in such a manner that there is a minimum of 10 cm between it and
other objects, including walls, in order to ensure proper air circulation.
•
Do not place the device where humidity or temperature are high as the device may
be damaged.
•
Before the first use the unit should stand for at least 2 hours before it is connected to
the power source.
•
Do not drill holes in the device nor mount other objects to it.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
•
Before first use, wipe the outside and inside of the device with a damp, soft cloth and
mild detergent. Thoroughly dry the device.
•
Connect the equipment to a single grounded outlet.
•
Turn on the device using the
ON/OF switch
on the rear wall inside the unit.
Temperature control
•
Using the thermostat you can adjust the temperature in the range of 2°C to 10°C.
•
To set the required temperature, turn the thermostat clockwise or counter clockwise.
Position
"1"
on the thermostat corresponds to the highest temperature (10°C),
position
"7"
corresponds to the lowest temperature (about 2°C) i nside the unit.
During cooling, the green LED indicator is lit. During the last 3 minutes of the cooling
phase the indicator flashes.
•
Close the door and leave it switched on, without inserting drinks until the inside of the
device has sufficient cooling capacity. After reaching the set temperature the green
LED indicator turns off.
•
At this point, drinks can be inserted in the device.
Summary of Contents for Bottle cooler 110.138
Page 1: ...110 138 V1 0111...