- 36 -
5. Installation and operation
5.1 Installation
CAUTION!
The installation and connection of the device should be made only by
qualified specialist establishment.
To avoid personal injury or damage to the device, we recommend two people
unpack and install the device.
Location
Unpack the device and remove and dispose of all package materials according to
the environmental protection regulations.
Leave the device on the palete.
Move the device only by lifting up (e.g. using a fork lift) to avoid damage to feet or
other accessories.
You can remove the palete when the device is placed in the installation location.
Pay attention not to hit the device.
Place the device on a sturdy, dry, flat and water and heat-resistant surface that will
suppor the weight of the fully loaded device.
Never
place the device on a flammable surface.
You must
not
position the device near open fire, electric furnaces, heaters or other
heat sources such as direct sunlight. Hight temperature may damage the surface of
the device as well as impair cooling performance and increase energy consumption.
To avoid damage to the compressor, do not tilt the device more than 45° during
transport and installation.
Place the device so that sufficient air circulation is ensured. Leave a 20 cm clearance
before walls and other objects.
Do not place the device in places of high air humidity. Excessive humidity may
damage the device. The device reaches its optimal operational conditions at an
ambient temperature from 10°C to 32 °C and relative air humidity from 30 to -55% in
the installation place.
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
Adjust the device using height-adjustable feet. Use a level, if needed. All feet must
stand on the floor. Only in this way the correct door opening and closing may be
ensured.
