- 27 -
When the crushing process finishes remove the collection tray. The contact switch is
thus automatically deactivated and the ice crusher will stop crushing.
If the glass lid catch is now released, the glass lid will return to its primary position and
the contact switch is automatically disconnected.
The device is equipped with an
overheating protection
device which deactivates
the motor if normal operating temperatures have been exceeded. In this event the
device should be left to cool as long as is necessary. The device can then again be
used for crushing ice.
Disconnect the device from its power source (remove the plug!) when not in use.
6. Cleaning
WARNING!
Before cleaning disconnect the device from the power
supply (pull the plug!).
Do not use any kind of pressure water jet for cleaning
the device.
Protect the device from the water penetration.
CAUTION!
Never use steel wool for cleaning. Its particles may loosen and get mixed
with the crushed ice in a beverage.
Never use sharp or scouring cleaning agents which may scratch the
surface of the device.
Never use aggressive cleaning agents of sprays.
o
Clean the device after every use, as well as after longer intervals between uses.
o
The device should be cleaned after each use, as well as after a long period of being
unused.
o
Remove the collection tray and water tray, and clean them.
o
Clean the collection tray with a mild cleaning agent and rinse thoroughly in clean
water. Replace it in its original position.
o
The water tray should be cleaned with a soft cloth, then replaced under the container
for crushed ice.
o
Open the filling chute and clean the inside with a brush and diluted cleaning agent.
Repeat the process 2-3 times.
