Installation and operation
16 / 24
125633-125633V1-125633V2
EN
LED Indicators
The LED indicators in the digital display show the status of the active function:
LED
Status of the
active function
Meaning
illuminates
the heater is working (the K1 output relay is on,
Act = 1)
flashes
during the heater delay time
The upper left point flashes in programming mode and lights when the external
contact (digital input) is active or in Standby mode.
The number "1" that appears on the digital display shows the current temperature of
the sensor.
Setting the temperature (required value)
1. Press the
button once for a moment.
The digital display shows “SET”. The upper point to the left of the temperature
gauge is flashing to indicate entering programming mode.
2. To display the set value, press the
button again.
3. To set the required set value, press the
or
button within 15 seconds.
4. Press the
button to confirm the set data.
NOTE!
If this button is not operated for more than 15 seconds (Timeout) or when
the
button is pressed once, the last value shown on the display will be
adopted and the previous message will be displayed again.
NOTE!
If additional parameter settings are necessary, contact technical service.