- 25 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.2 Operation
•
Before the device operation clean it according to the instructions in
section 6 “Cleaning”.
•
Prepare appropriate sausages for heating.
•
Before turning the device on place the tray for the dripping fat under the rollers, put
the grate in the tray when required. The mentioned elements must be clean and dry.
•
Heat the device before placing the sausages.
•
The surface with the rotating rollers is divided into 2 separately controlled heating
zones: front heating zone with 4 rollers and back heating zone with 3 rollers.
•
Temperature in each zone is adjusted in range of 1-10 with use of appropriate
front knobs of temperature control. Depending on the number of sausages one or
both heating zones may be activated.
•
The orange lamps illuminate during heating and go off when the preset
temperature is reached. When the rollers temperature drops the heaters are
activated and the orange lamps go on again.
•
After reaching the preset temperature the prepared sausages may be placed on
the rollers. The number of sausages (of standard size) is 18, 3 in each row.
•
In order to obtain the uniformity turn the ON/OFF switch on to position „I“.
Summary of Contents for 104915
Page 1: ...104915 V1 0315 ...
