Barton 99830, Owner'S Manual And Safety Instructions

Page: 11 / 16

OPERATION OPERATION
10
LOADING THE BASKET:
STARTING A WASH CYCLE:
1. Draw out the basket(see the section entitled Loading the Dishwasher );
2.
Pour in the detergent (see the section entitled Detergent and Rinse Aid );
3. Insert the plug into the socket. The power supply is 120V/60 Hz;
4. Make sure that the water supply is turned on to full pressure;
5. Close the door and press the power button to turn on the power supply.
6. Press the Program button to select the wash program you need. NORMAL > LIGHT > MINIPARTY >
RINSE > SPEED > HEAVY
7. Then press the START / RESET button and the dishwasher will begin to start.
CHANGING THE PROGRAM:
You can modify the washing program if the dishwasher runs for a short time. Otherwise, the detergent
may have already been released, and the appliance may have already drained the wash water. If this is
the case, the detergent dispenser must be refilled (see the section titled “ Loading Detergent “
To change the washing program, more than three seconds the machine will be in stand by state, then
you can change the program to the desired cycle setting. See Starting Wash Cycle section. The lights
show the state of the dishwasher:
A) All phase lights off: Stand By
B) Display not blinking: Paused
C) Display is blinking: Running
NOTE: If you open the door when washing, the machine will pause. When closing the door, press the
START button to start the wash cycle back up.
END OF WASH CYCLE:
When the working cycle has finished, the buzzer will sound for 8 seconds, then stop. Turn off the
appliance using the Power button, shut off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better. Since the appliance is
standing by, it will power off automatically after 30 minutes without any operation
TURNING OFF THE DISHWASHER:
All phase lights are off indicating the program has ended.
1. Turn off the dishwasher by pressing the POWER button.
2. Make sure to turn off the water tap.
NOTE: Take care when opening the dishwasher and handling dishes, they will be hot. After a wash has
ended, it is recommended to leave the door open for 30 minutes before unloading.
STARTING THE DISHWASHER:
Check to make sure the following steps are followed
1. The dishwasher is level and fixed properly.
2.
The inlet valve is open
3. There are no leakages at the connections of the conducts
4.
Wires are tightly connected
5. Power is switched on
6. Inlet and drain hoses are knotted