Created: 07/04
Revised: 08/14
BARTELL MORRISON INC. BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
200 COMMERCE DRIVE, FREEHOLD, NEW JERSEY, USA, 07728 732-566-5400 FAX 732 -566-5444
EDGER TROWEL INSTRUCTION MANUAL
BARTELL MORRISON INC.
BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
25 INDUSTRIAL DRIVE, KEYPORT, NEW JERSEY, USA, 07735, 732-566-5400 FAX 732-566-5444
Created: 07/04
Revised: 06/12
- 11 -
NOTE: THE LUBRICATION SYSTEM SHOULD BE
CHECKED AT LEAST ONCE PER MONTH TO
ENSURE THAT THE UNIT IS FUNCTIONING
PROPERLY.
3. GEARBOX
In operation the gearbox lubricant is in a fluid state.
When the machine is stopped the lubricant returns
to a gel state. It will only be necessary to inspect the
sealed components if the outside of the gearbox
gets too oily or otherwise shows evidence of a leak.
If this happens, clean the machine thoroughly and
look for leaks. Effect necessary repairs immediately.
Use SHELL TIVELA COMPOUNDS ‘A’ (0.3L,
10.1oz.) gear oil or equivalent to top up the gear box
after any maintenance to the internal components.
STORAGE
The following steps should be taken to prepare your
Edger Power Trowel for extended storage.
1. Close fuel shut off valve.
2. Siphon excess gasoline from tank.
3. Start engine until it stops from lack of fuel. This will
use up all the fuel in the carburetor and prevent
formation of deposits due to evaporation of fuel.
4. Remove spark plug and pour 2 oz. of SAE-30 or
SAE-40 motor oil into the cylinder. Slowly crank the
engine 2 or 3 times to distribute the oil throughout
the cylinder. This will help prevent rust during
storage. Replace spark plug.
5. Store the unit in an upright position in a cool, dry,
well ventilated area.
THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK
- 16 -
