CT320 FLOOR PLANER/SCARIFIER
OWNER’S MANUAL AND PARTS BOOK
10
OIPB
– C15005
OPERATION
Operating
After mounting the appropriate tools, the operation of the Planer can begin.
Switch the motor on and lower the planar with the lever to the operating position. Turn the hand
wheel height adjustment until the tools are lowered to the floor. Keep turning the handwheel
until you reach your desired finish
Dust emission should be prevented by connecting a dust collector.
Stopping Procedure
Turn the machine off and raise the cutters off the floor using the lever and/or hand wheel.
Disconnect the cord if you are done with the machine.
ATTENTION:
Lowering the tools too much decreases the performance of the
machine. You will destroy the shafts in the drum and the bearings of the machine.
ATTENTION:
Never switch on machine while the grinding head is on the floor.
ATTENTION:
Lowering cutter adjuster too far will cause cage shafts to pinch cutters
between the shaft and the surface. This will cause cutters shafts and cage to break. The
cutters should always be able to move freely.
