Safety
Ex p control unit
Motor Purge Controller
Page 12 of 96
01-37A2-7D0003_Operating instructions_MPC_20210923_0_en.docx
Rev. 0
2.4
Safety information
General
Do not dry wipe or clean devices in potentially explosive areas!
Do not open devices in potentially explosive areas.
General legal regulations or guidelines on occupational safety, accident
prevention regulations and environmental protection laws must be
observed, e.g. Industrial Safety Ordinance (BetrSichV) or nationally
applicable ordinances.
Wear suitable clothing and footwear because of the risk of dangerous
static electricity build-up.
Avoid the effects of heat outside the specified temperature range (see
chapter on general technical data).
Avoid the effects of moisture.
Operational safety information
Installation
Before the installation, it must be checked that all components and
documents are available.
Inspection
According to EN / IEC 60079-17 /
ГОСТ
IEC 60079-17-2013, the operator of
electrical systems in potentially explosive areas is obliged to have them
checked for proper condition by a qualified electrician.
Repairs
The relevant installation and operating regulations must be observed for
electrical systems (e.g. RL 99/92 / EG, RL 2014/34 / EU, BetrSichV or the
nationally applicable regulations EN / IEC 60079-14 /
ГОСТ
IEC 60079-14-
2013 and the DIN VDE 0100 series)!
Please observe the national waste disposal regulations for disposal.
Maintenance
If the device is operated properly, considering the installation instructions
and ambient conditions, no constant maintenance is required.
BARTEC recommends performing annual maintenance and testing.
See chapter on maintenance and care.