
T e c h 3 0 0
User Guide R.59.1
2 0 2 0
13 |
P a g e
As well as the pressure and
temperature, we also display the “mode” of the sensor. In some
cases the mode cannot be changed and isn’t important, but in some cases it will need to be
changed in order for the relearn to work.
For example if sensors for a vehicle show “Park” or “Drive”
they are already in the correct mode.
Otherwise use the “Set to Park” command in the Relearn Toolkit. If the sensors are shown as
Ship, Off or Test mode, put them in Park mode, using the “Set to Park” command in the Relearn
Toolkit.
To access the Relearn Toolkit, use the up and down arrows to select the spanner symbol in the
top left corner.
Special service advice for Toyota Models:
Toyota ECU
Reset
If at any time the vehicle TPMS Reset button is pressed with the new
sensor IDs fitted, the ECU OBD relearn will not work until the Toyota
ECU Reset is selected (with the tool connected to OBD). The TPMS
Reset button should only be used to set new tyre pressures, and on
some vehicles to change between winter and summer ID sets.
Special service advice for Kia and Hyundai Models:
•
Reset YD Sensor
For some Kia and Hyundai vehicles with the newer low line TRW YD
sensors, this allows you to put the sensors back into the correct mode
(Sleep or Rest) to work with the vehicle.
These specific Service advices will only appear if applicable for the preselected Make,
Model and Year combination.
4/6
OBD
D
IAGNOSTICS
OBD
Diagnostics
This option will only be
listed for vehicles that
Bartec
has
OBD
coverage for. It reads
information from the
vehicle such as the VIN,
DTCs
(Diagnostic
Trouble Codes) and the
IDs of the sensors.
Relearn Toolkit
OBD
Set Sensor to Park Mode
Press Test To Activate Left Front
07/2011>10/2016 Evoque
Check Sensor
Programmable Sensor
Relearn
OBD Diagnostics
Technical Information
Review Vehicle Data
4/6