12
Search Coil Sweeping Hints:
•
Never sweep the search coil as if it were a pendulum. Raising the
search coil while sweeping or at the end of a sweep will cause false
readings.
•
Sweep slowly hurrying will cause you to miss
targets.
•
It’s better you sweep the search coil from side to
side in an arc line of 3 inches motion and keep the
search coil parallel with the ground.
If the detector detects the item, it sounds a tone, an arrow and the depth
appear on the display below the target icon.
If the detector does not detect the item, make sure that the target mode is set
correctly for the type of metal you’re searching for. Make sure that you’re
moving the search coil correctly.
Notes:
•
The detector responds with a signal when it detects most valuable
metal objects. If a signal does not repeat after you sweep the search
coil over the target a few times, the target is probably junk metal.
•
False signals can be caused by trashy ground, electrical interference,
or large irregular piece of junk metal.
•
False signals are usually broken or non-repeatable.
Adjusting SENSITIVITY
After you become familiar with how your detector works, it’s important to fine
tune the sensitivity to get a good effect.
Press the touch button SENS on the panel. Then press + or - to increase or
decrease the sensitivity. The level on the segment will be displayed from high
to low position.
Summary of Contents for WINBEST Elite Edition
Page 16: ...BC192 ...
