Setup Instructions
Unpack and lay out all of the parts in a large, clear area where you will have
room to assemble the pieces.
1. Fully extend the legs of the tripod apart
2. On the head of the tripod is the Vertical Axis Screw and lock nut. Separate the
Vertical Axis Screw from the lock nut by holding the Vertical Axis Screw in
place and unscrewing the lock nut off the screw
3. Under the base of the telescope is the mounting platform. Align the head of the
tripod to the mounting platform so that the screw in the mounting platform lines
up with the holes of the mounting platform. Insert the Vertical Axis Screw
through the holes to attach the tripod to the telescope pieces together with
lock nut.
Initial set up is shown in the picture on the left. Should look like picture on the
right when finished.
4. Remove caps from telescope
Note: When mounting the parts ensure that the securing screws are not tightened
too tightly. Tightening too tightly could result in damage the parts or the internal
thread of the holders.
w w w . b a r s k a . c o m
2
450 Power, 60050 Starwatcher Telescope
450 Power, 60050 Starwatcher Telescope
3
w w w . b a r s k a . c o m
1.
Tripod Brace with Leg
Adjustment Screw
2.
Tripod Leg
3.
Objective Lens
4.
Telescope Main Body
5.
Finder Scope
6.
Finder Scope Bracket
7.
Eyepiece
8.
Diagonal
9.
Focus Knob
10. Vertical Axis Screw
11. Horizontal Axis Screw
CAUTION: DO NOT LOOK DIRECTLY AT THE
SUN. VIEWING THE SUN OR ANY LIGHT
SOURCE WITH THIS OPTICAL DEVICE CAN
CAUSE PERMANENT EYE DAMAGE.
1
2
3
4
6
5
7
8
9
10
11
