Barry-Wehmiller Accraply 204RH, Operation And Maintenance Manual

Page: 40 / 97

32 SECTION 1: SYSTEM OPERATION
MAINTENANCE
1.6.2 Preventive Maintenance
Follow the preventative maintenance suggestions and instructions to ensure long machine life and excellent
performance.
FREQUENCY ACTIVITY INSTRUCTION
Daily Keep the Labeler clean
and free of dust and dirt.
Use a lint cloth, a soft bristle brush and a
mild detergent solution.
Do an overall visual and
audible inspection of the
Labeler.
Look for hardware security and listen for
unusual noises.
Remove all adhesive
buildup.
ONLY use Isopropyl alcohol. Clean both
painted and unpainted metal surfaces.
Check the rewind
spindles.
Check for serviceability.
Test Labeler by manually
operating through one
cycle (if applicable).
Check security and serviceability.
Verify solenoid function. Confirm LED operation.
Inspect for air leakage. Air leakage can be found by listening for
noise along the pneumatic system.
Weekly Inspect each sensor. Verify the alignment and replace if required.
Check condition of all
solenoids.
Replace if required.
Check all mounting screws
and other hardware.
Verify tightness and adjust if required.
Check operation of all
electrical controls for
serviceability.
Replace if required.
Remove condensation
from air filter.
Open the drain valve.
Inspect air hoses. Ensure hoses are not twisted or flattened.
Monthly Check brake and feed
roller for wear.
Replace if required.
Check label dispensing
edge and pad (if used) for
serviceability.
Replace if required.
90-Day
Service
Check all items listed
above.
Check all items listed above.
Annually Check DC motor brushes Replace if required.