RDG603A29
– Issue 4
Page 17 of 24
SECTION 5
– Operation
NOTICE:
REFER TO THE YANMAR MANUAL PRIOR TO STARTING THE ENGINE.
1. Starting the engine for the first time
•
Remove ignition key.
•
Ensure all oil and coolant levels are checked.
•
Ensure both the engine and domestic batteries are connected. All battery master
switches must be turned on. Failure to do so may damage the domestic alternator.
•
Ensure that the raw water seacock is turned on.
2. Starting Procedure
•
Ensure there is no one in the engine compartment.
•
Ensure the engine compartment door is closed.
•
Ensure the gearshift control lever & throttle lever are set to neutral and that all persons
are clear of any moving parts.
•
Insert ignition key.
•
Turn key to on position.
•
The engine will start to crank for a set period of time and then start.
•
If the engine fails to start, it will try this procedure a further two times. If the engine still
fails to start the “Fail to Start” light will illuminate. Turn the key to stop position and
contact the operator.
•
Stop engine if any abnormal noises are detected.
•
Visually check the engine for oil, fuel and coolant leaks, after initial start-up and at
regular intervals. Note: Engine must be stopped to carry out this check).
3. Stopping Procedure
•
Move gearshift control lever & throttle lever to idle position.
•
Turn key to off position.