Fig. 2
Fig. 1
How to Install LiteLogic App?
How to Control Lights with a Phone?
Scan QR Code below to download the APP.
Wiring (Fig. 1)
1. Remove current wall plate mounting screws.
2. Carefully remove the switch from the switch box. DO NOT disconnect
the wires.
3. There are three wiring connections on the switch, these are marked
HOT, NEUTRAL and GROUND.
4. Disconnect the wires from the existing switch.
5. Connect the green wire to the GROUND terminal.
6. Connect the white wire to the terminal marked NEUTRAL.
7. Connect the black wire to the terminal marked HOT.
8. Check connections to be sure they are tight and no bare conductors
are exposed.
9. Insert the switch into the outlet box carefully.
10. Make sure to attach the switch to the box using the supplied screws.
11. Attach the wall plate.
12. Restore power to the circuit breaker and test the system.
Installation (Fig. 2)
1. Follow the instructions to connect bluetooth wall switch to the lights.
(Fig. 1)
2. Press buttons and together for over 3 seconds to enter pairing
mode or achieve reset function. This switch can be scanned in the
next 30 seconds. (Fig. 2)
3. In the LiteLogic App “Switch” page, click to add the switch.
4. Select the light / light group to be controlled by this switch.
5. For detailed operation please refer to LiteLogic App instructions.
NOTE: This Bluetooth device is compatible with
LiteLogic lighting control system only.
LE-SW3
Installation Instructions
20070207 REV 1 - 10/23
2
800-533-3948 www.barronltg.com
Scan the QR Code below for APP instructions.
