INSTALLATION INSTRUCTIONS
800.533.3948
•
www.barronltg.com
2
40070009 REV 1 11/2014
RFX
General Material/Tool Requirements:
1. Measure the installation location to determine product length. Due to circuitry, RFX has a 2” cutting increment.
2. Measure the RFX to match required installation length. Locate the closest
cutting mark. This is designated by a line between 4 copper pads. (Fig. 1)
3. Using scissors, make an even cut through product exactly on the line. If cut
off the line the product can be damaged.
NOTE:
It is imperative to use a sharp cutting blade to make a straight cut.
Sharp blades will help you avoid pulling the internal circuitry while making
the cut. Stretching or pulling the product can result in damage.
4. Connect the transformer to the wire leads of the RFX in accordance with current electrical codes and the
current National Electric Code (NEC). Transformers are IP67 rated / Class 2 power supplies. Install the transformer
within 10’ of the RFX.
5. Test product to verify connections are correct.
6. Adhere product to surface. Do not push directly on LEDs as this will cause damage to LEDs.
Material needed for installation:
RFX Ribbon Flex Reel (16.4’)
RFX Transformer
RFX accessories (Optional)
Additional wire as needed for connections
Measuring tape
Scissors
Part Number - 12 volt
XFMR-12-20
XFMR-12-35
XFMR-12-60
XFMR-12-150
XFMR-DIM-12-20
XFMR-DIM-12-40
XFMR-DIM-12-60
XFMR-DIM-12-96
XFMR-DIM-12-120
RFX-*-12V (2.25W/Ft)
7.1’
12.44’
21.33’
50.00’ MAX
7.10’
14.22
21.33’
34.13’
42.66’
RFX-*-12V-5050 (5.56W/Ft)
2.87’
5.04’
8.63’
21.58’
2.87’
5.75’
8.63’
13.80’
16.4’
Part Number - 24 volt
XFMR-12-20
XFMR-12-35
XFMR-12-60
XFMR-12-150
XFMR-DIM-12-20
XFMR-DIM-12-40
XFMR-DIM-12-60
XFMR-DIM-12-96
RFX-*-24V (2.25W/Ft)
7.1’
12.44’
21.33’
50.00’ MAX
7.10’
14.22
21.33’
34.13’
RFX-*-24V-5050 (5.56W/Ft)
2.87’
5.04’
8.63’
21.58’
2.87’
5.75’
8.63’
13.80’
Fig.1
Cut Line
Copper Pads
