8. Make electrical connections: see Electrical Connection sections.
9. Mount the sign to the junction box with (2) #8-32 screws (provided) and tighten securely.
10. Remove the chevron(s) from the EXIT legend(s) if necessary.
11. Attach the battery jumper wire (for battery backup unit) to the PC board only after continuous AC power can be
supplied to the unit.
12. Slide the faceplate back into place and replace the screw.
Wall Mounting
1. Remove the faceplate by removing the screw from the bottom of the unit, then slide the faceplate down and set
aside.
2. Remove knockouts from the backplate that match the junction box.
3. Route the units input wires through the center wire access hole of the backplate and make the wiring connections.
4. Make electrical connections: see Electrical Connection sections.
5. Push the wires against the back of the sign to minimize any chance of the wires interfering with the illumination of
the letters.
6. Mount the sign to the junction box with (2) #8-32 screws (provided)
and tighten securely.
7. Remove the chevron(s) from the EXIT legend(s) if necessary.
8. Attach the battery jumper wire (for battery backup unit) to the PC board.
9. Slide the faceplate back into place and replace the screw.
Electrical Connections
All electrical connections should be made inside the junction box.
Make Electrical Connections as follows:
120V AC 277V AC
White - Common White - Common
Black - 120VAC Red/Orange - 277VAC
Green - Ground Green - Ground
Note:
Cap unused leads to prevent shorting.
800.533.3948 • www.barronltg.com
2
INSTALLATION INSTUCTIONS
10070182 Rev 3 - 02/19
VEX-S SERIES
Battery Backup
AC Only