Ceiling and End Mounting
1. Remove the faceplate by removing the screw from the bottom of the unit, then slide
the faceplate down and set aside.
2. Remove both the circular and rectangle knockouts from either the top or side of
the unit.
3. Slide one square nut from the threaded stem rod hardware into the slot located
inside the housing.
4. Line up the canopy with the knockout holes and push the clip through rectangular
knockout to lock into place.
5. Feed the AC supply and ground wires from inside the unit through the nut, threaded
stem, canopy, and mounting plate.
6. Screw the threaded stem rod, lock washer, and the square nut through
the canopy and unit, ensure the hardware is tightened securely.
7. Determine the position and direction for the emergency sign. Then using
the round mounting plate, align the unit with the junction box.
INSTALLATION INSTUCTIONS
800.533.3948 • www.barronltg.com
1
INSTALLATION INSTUCTIONS
10070182 Rev 3 - 02/19
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
VEX-S SERIES
Fig. 1
Fig. 2
