background image

IMPORTANT SAFEGUARDS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

   

·

 

DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

·

 Installation and servicing of this equipment should be performed by qualified service personnel only.

·

 Ensure that the electrical wiring conforms to the National Electrical Code NEC?and local regulations if 

applicable.

·

 Do not mount near gas or electrical heaters.

·

 Suitable for damp locations. Do not use outdoors.

·

 Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by 

unauthorized personnel.

·

 The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. 

·

 Any modification or use of non-original components will void the warranty and product liability.

·

 Do not use this equipment for other than intended use.

·

 

For -WB version:

·

 Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin 

or in eyes, flush acid with fresh water and contact a physician immediately.

 

SAVE THESE INSTRUCTIONS!

Technical Support ■ (623) 580-8943 ■ [email protected]

Installation Instructions

 

10070267 

REV 1 - 08/22

1

800-533-3948 www.barronltg.com

When using electrical equipment, basic safety precautions should always be followed including the following:

CH900X Series

Allow battery to charge for 24 hours before first use.

Summary of Contents for Exitronix CH900X Series

Page 1: ...ccessory equipment not recommended by the manufacturer may cause an unsafe condition Any modification or use of non original components will void the warranty and product liability Do not use this equipment for other than intended use For WB version Use caution when servicing batteries Battery acid can cause burns to skin and eyes If acid is spilled on skin or in eyes flush acid with fresh water and...

Page 2: ... connect the battery connectors WB 3 Hang the safety rope to the module clip Fig 2 4 Disassemble the J box cap then route the AC line and proper wires into the J Box 5 Make electrical connections see Electrical Connections section 6 Push excess wire into the J Box and tighten the J box cap 7 Reassemble the trimplate using the M3 15mm screws 8 Connect the light bar connector then insert the panel m...

Page 3: ...g wires through the back of the fixture 4 Make electrical connections see Electrical Connections section 5 Mount to the J box 6 Energize the AC supply the LED indicator will come on 7 Assemble the EXIT panel to the enclosure using screws If the EXIT panel is single face be sure the EXIT lettering is facing the right direction 8 Replace the front cover to finish installation Fig 7 Flag Mount Fig 5 Su...

Page 4: ...ery power WB 2 Release the test switch and the EXIT sign will operate with AC supply 3 Servicing of any parts should be performed by qualified personnel For replacement parts see fixture label for proper identification of manufactory 4 Replace batteries according to ambient conditions WB Equipment should be tested regularly in accordance with local codes Wiring Diagram Batt Led strip White COMMON Bla...

Reviews: