J123325-JL
Page 3 of 6
03/12/18
1/2” from the end of the installed Rear Window Bracket.
Use (2) 8mm x 25mm Combo Bolts to secure
the Clamping Bracket to the Mounting Bracket,
(Figures 10—13)
. Do not tighten hardware.
13.
Repeat
Steps 11 & 12
for passenger/right side installation of the front Brackets.
14.
With assistance, place the assembled Roof Basket on top of the Brackets. Attach the Rear Brackets to
the Roof Basket with (4) 8mm x 25mm Hex Bolts, (8) 8mm x 24mm Flat Washers and (4) 8mm Nylon
Lock Nuts,
(Figures 14 & 15)
. Leave hardware loose at this time.
15.
Attach the Front Mounting Brackets to the mounting tabs on the Front Cross Bar using (4) 8mm x 25mm
Hex Bolts, (8) 8mm x 24mm Flat Washers and (4) 8mm Nylon Lock Nuts,
(Figures 16 & 17)
. Do not
fully tighten hardware.
NOTE:
Adjust the Clamping Brackets forwards or back to line up with Brackets, if
necessary.
16.
Level and center the Roof Basket to the vehicle and tighten all hardware at this time.
17.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Roof Basket.
(3) 8mm x 25mm Button Head Bolts
& (1) 8mm x 50mm Hex Bolt
(8) 8mm x 24mm Flat Washers
(4) 8mm Lock Washers
(4) 8mm Hex Nuts
(Fig 1) Use the 8mm x 50mm Hex Bolt to attach
the Front Cross Bar to the bottom of the Panels
(Fig 2) Hardware illustrated to
secure Rear Panels
(4) 8mm x 25mm Button Head Bolts
(8) 8mm x 24mm Flat Washers
(4) 8mm Lock Washers
(4) 8mm Hex Nuts
Rear
(Fig 3) Cross Rail attached to the Side
Panels illustrated from below
(2) 8mm x 25mm Button Head Bolts
(2) 8mm Lock Washers
(2) 8mm x 24mm Flat Washers
(Fig 4) Attach the Face Plate to the Front Panel
Front
(2) 6mm Button Head Combo Bolts
(2) 6mm Flat Washers
(2) 6mm Hex Nuts
Front
