3x6’ DECORATIVE SCREEN PANEL
FRAME KIT ASSEMBLY INSTRUCTIONS
Warning
• Read all instructions before installing the product.
• When using tools, refer to the manufacturer’s safety instructions.
• Make sure the posts will be held in place by a sturdy structure and
reinforce the surface it stands on as necessary.
• Improper product installation can cause injury. Always wear safety
glasses when cutting, drilling and assembling the product.
• Improper installation may cause product damage or injury to the
person performing the installation.
• Check the local building code to determine if the product meets the
pool fencing requirements.
NOTE
• DO NOT assemble the product if there are missing or damaged parts.
• DO NOT return the product to the store. For help or replacement
parts, call 1‐800‐336‐2383.
Kit contains:
‐ (2) 2" Aluminum End Posts
‐ (2) Top/Bottom U‐Channels (Rail)
‐ (1) Mid H‐Channel (Rail)
‐ Surface Mount Kit
‐ (2) Post Caps
‐ Hardware (Screw kit)
‐ #2 square drive drill bit
‐ #3 Phillips drive drill bit
‐ 1/8” Metal Drill Bit
Required,
Sold Separately:
‐ (2) 3x6 Decorative Screen Panels
‐ 3/8” Bolts/Screws for mounting base plates to a structure
Optional to Connect Frame Kits, Sold Separately:
‐ Line Post Extension Kits #73045673
‐ Corner Post Extension Kits #73045674
Tools Needed:
‐ Drill
‐ Pencil
‐ Tape Measure
‐ Rubber Mallet
‐ 3" Spacer Blocks
‐ 1/8” Metal Drill Bit
Step 1
Determine where you would like to install the frame kit. Make
sure the posts will be held in place by a solid structure and if
necessary reinforce the surface it stands on. Then, lay posts
down flush on a flat surface or table.
Step 2
Install base plates to bottom of posts. Locate bottom post with
pre‐tapped holes and attach the bottom plate to that end.
Using only the #3 Phillips drive drill bit provided in surface
mount kit, screw base plate to bottom of post through the 4
screw bosses. Drill should be set to low speed when securing
plates to post.
Step 3
Set first post in desired location. Ensure mounting surface has
proper structure to hold post before fastening in place. Use
the post assembly to mark the holes for the surface mounting
plate. Mark and drill holes for appropriate 3/8” fasteners
(fasteners will vary depending on mounting surface).
Before You Begin:
This product is intended for decorative
use only. It is the responsibility of the installer to meet
and/or exceed all code and safety requirements and to obtain
required building code permits as necessary.
