OWNER’S MANUAL 8/31/21 Page 14 of 18
BATTERY MAINTENANCE
WARNING:
Read the section:
BATTERY SAFETY INSTRUCTIONS
, before handling the
battery.
The original battery equipped on the STK is considered to be “maintenance free”. However, some
maintenance will help your battery last longer. Temperatures below freezing or over 90°F (32°C) will
reduce the life of the battery. If the battery is not going to be used for a season, store it fully charged in
an area where the temperature will stay between freezing and 90°F (32°C). This will help prolong battery
life.
NOTICE:
Battery acid is corrosive and can damage your machine. Keep the battery clean and avoid
getting battery acid on your machine.
Always recycle / dispose of your old batteries properly. Most places that sell automotive batteries will take
your old battery. DO NOT dump your battery. DO NOT put your battery in a dumpster.
Always replace any damaged battery or battery components, such as wires, clamps, lugs, fasteners, isolators,
covers, etc.
To remove your battery:
Engine must be off. All engine switches must be in the OFF position.
•
Disconnect the ground cable at the chassis and position it to not touch any component.
•
Disconnect the ground cable at the battery and set it aside.
•
Disconnect the positive cable from the battery; the cable may remain connected to starter motor.
•
Remove the battery from holder. Place on a clean, dry, level, non-conductive surface. Keep away
from flames, sparks and heat sources.
•
DO NOT store where the ambient temperature is less than freezing or hotter than 90°F (32° C).
To install your battery:
Engine must be off. All engine switches must be in the OFF position.
•
Place battery in battery compartment.
•
Connect the positive cable to the battery and the starter motor.
•
Make sure that the ground cable is not touching any machine component.
•
Connect the ground cable to the battery.
•
Install the battery isolator and cover.
•
Connect the ground cable to the chassis.
To clean your battery:
information from www.interstatebatteries.com
•
Disconnect your battery. See:
To remove your battery:
the battery may remain in the holder.
•
Make sure vents caps are pressed securely into battery.
•
Clean terminals and lugs with a mixture of baking soda and water. A wire brush may be used.
•
Clean STK components near the battery with baking soda and water. DO NOT use a wire brush.
•
Rinse with clean water and allow enough time for water to dry.
•
Coat terminals and wire lugs with dielectric grease.
•
Connect your battery. See:
To install your battery:
